Kia Optima Manuals

Kia Sportage: TPMS Sensor: Description and Operation - Tire Pressure Monitoring System - Suspension System - Kia Sportage SL Service & Repair ManualKia Sportage: TPMS Sensor: Description and Operation

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor: Description and Operation

Description

1.
Mode
(1)
Normal Fixed Base State
•
Sensor transmissions continue at the Low Line (Base) configuration defined rates until the state is either changed by LF command or by the sensor detecting a condition that requires a temporary change to another state.
•
The LF command to this state must contain the sensors ID.
(2)
Storage Auto State :
•
This state is a Low current consumption state.
•
Sensors are in this state when they first arrive at the dealership (either on the vehicle or as replacement spares).
•
In this state, the sensor does not measure pressure / temperature / battery level.
•
The sensor will not transmit in this state unless requested to do so by the initiate command.
(3)
Alert State :
•
The sensor automatically enters this state if the measured temperature exceeds 230 °F(110 °C) and over temperature shutdown is likely.
•
In this state, pressure is measured every 4 seconds and RF data transmitted every 4 seconds.
•
The state lasts for 1 minute if it is pressure triggered.
•
This state is alse entered when a 3 psi change in pressure from the last RF transmission occurs.
   
Sensor mode is used to configure sensor between high line and low line system. TPMS sensor for UB should be set to low line.
Troubleshooting
TPMS Inspection method Inspection     Find the inspection number by referring to the table above. The following content is irrelevant of the inspection procedure. 1. ...

TPMS Sensor: Repair procedures
Removal Tire Removal 1. Deflate tire & remove balance weights.     Sensor can be unscrewed before unseat the tire bead.     • Th ...

Other Information:

High Pressure Fuel Pump: Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pre ...

Rear Shock Absorber: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Categories

Copyright www.kispmanual.com 2014-2026