Kia Sportage: Anchor Pretensioner: Repair procedures| Removal |
| 1. |
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. |
| 2. |
To remove the seat belt anchor pretensioner (C), keep on
pushing the lock pins (A) as arrow direction. And then remove the seat
belt after pushing the lock pin (B).
|
| 3. |
Remove the following parts. (Refer to the Body group-Interior trim)
|
| 4. |
Disconnect the anchor pretensioner connector (A).
|
| 5. |
Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner. |
| Installation |
| 1. |
Remove ignition key from the vehicle. |
| 2. |
Disconnect the negative (-) cable from battery and wait for at least thirty seconds. |
| 3. |
Install the anchor pretensioner with a bolt.
|
| 4. |
Connect the anchor pretensioner connector. |
| 5. |
Install the following parts. (Refer to the body group - Interior trim)
|
| 6. |
Insert the seat belt to the anchor pretensioner.
|
| 7. |
Reconnect the battery negative cable. |
| 8. |
After installing the anchor pretensioner, confirm proper system operation:
|
Anchor Pretensioner: Components and Components Location
Brake SystemInput Speed Sensor: Troubleshooting
Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Vehicle stability management (VSM)
This system provides further enhancements to vehicle stability and steering responses
when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient
of friction between ...