Kia Optima Manuals

Kia Sportage: Audio Unit: Repair procedures - Audio - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Audio Unit: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Audio / Audio Unit: Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad passenger''s garnish (A).
(Refer to BD group - "Crash pad")

3.
Disconnect the connectors and remove the cluster fascia panel (A).
(Refer to BD group - "Crash pad")

4.
Remove the center fascia panel (A) after loosening the mounting screw (2EA).

5.
Disconnect the connector (A) installed on the center fascia panel.

6.
Remove the audio assembly (A) after loosening the mounting screw (4EA).

7.
Disconnect the audio connectors and cable (A), then remove the audio unit completely.

   
Lift the connector locking clip to the arrow direction, disconnect the connector.
When assembling, install the connector and connector locking clip.
   
–
If CD does not eject, don''t try to remove it.
–
The player may be damaged.
–
Therefore, contact a service shop for repairs.
Installation
1.
Connect the audio unit connectors and cable.
2.
Install the audio unit.
3.
Install the center fascia panel.
4.
Install the cluster fascia panel.
5.
Install the crash pad passenger''s garnish.
6.
Connect the negative (-) battery terminal.
   
a.
Make sure the connector are connected in properly.
b.
Check the audio system.
Disassembly
1.
Loosen the screw (Left 3EA, Right 3EA) and remove the audio head unit mounting bracket (A).

2.
When separate the CD rom drive, if necessary, remove the top cover (A) after loosening the screws (4EA).

3.
After loosening the screws, remove the CD rom drive(B).

   
Take care not to damage the cable connectors (A) when removing drive.
Audio Unit: Components and Components Location
Components Connector Pin Information No.Connector AConnector B1Speaker RL (+)MM CAN HIGH 2Speaker FL (+)-3Speaker FR (+)-4Speaker RR (+)Steering Remote5--6-USB D (+)7-USB/iPOD VDD8Illuminat ...

Speakers: Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector ...

Other Information:

Main fuse and multi fuse
If the main fuse and multi fuse is blown, it must be removed as follows: 1.Disconnect the negative battery cable. 2.Remove the nuts shown in the picture above. 3.Replace the fuse with a new one o ...

26 Brake Control Solenoid Valve(26/B_VFS): Specifications
Specifications Direct control VFS[26/B] ? Control type : Normal low type Control Pressure kpa (kgf/cm?, psi)9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal resist ...

Categories

Copyright www.kispmanual.com 2014-2026