Trouble Shooting |
Symptom | Suspect area | Remedy |
Engine will not start or is hard to start (Cranks OK) | Ignition lock switch | Inspect ignition lock switch, or replace as required |
Ignition coil | Inspect ignition coil, or replace as required | |
Spark plugs | Inspect spark plugs, or replace as required | |
Ignition wiring disconnected or broken | Repair wiring, or replace as required | |
Rough idle or stalls | Ignition wiring | Repair wiring, or replace as required |
Ignition coil | Inspect ignition coil, or replace as required | |
Engine hesitates/poor acceleration | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
Ignition wiring | Repair wiring, or replace as required | |
Poor mileage | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
Symptom | Suspect area | Remedy |
Charging warning indicator does not light with ignition switch "ON" and engine off. | Fuse blown | Check fuses |
Light burned out | Replace light | |
Wiring connection loose | Tighten loose connection | |
Electronic voltage regulator | Replace voltage regulator | |
Charging warning indicator does not go out with engine running. (Battery requires frequent recharging) | Drive belt loose or worn | Adjust belt tension or replace belt |
Battery cable loose, corroded or worn | Inspect cable connection, repair or replace cable | |
Electronic voltage regulator or alternator | Replace voltage regulator or alternator | |
Wiring | Repair or replace wiring | |
Overcharge | Electronic voltage regulator | Replace voltage regulator |
Voltage sensing wire | Repair or replace wiring | |
Discharge | Drive belt loose or worn | Adjust belt tension or replace belt |
Wiring connection loose or short circuit | Inspect wiring connection, repair or replace wiring | |
Electronic voltage regulator or alternator | Replace voltage regulator or alternator | |
Poor grounding | Inspect ground or repair | |
Worn battery | Replace battery |
Symptom | Suspect area | Remedy |
Engine will not crank | Battery charge low | Charge or replace battery |
Battery cables loose, corroded or worn out | Repair or replace cables | |
Transaxle range switch (Vehicle with automatic transaxle only) | Refer to AT group-automatic transaxle | |
Fuse blown | Replace fuse | |
Starter faulty | Replace | |
Ignition switch faulty | Replace | |
Engine cranks slowly | Battery charge low | Charge or replace battery |
Battery cables loose, corroded or worn out | Repair or replace cables | |
Starter faulty | Replace | |
Starter keeps running | Starter | Replace |
Ignition switch | Replace | |
Starter spins but engine will not crank | Short in wiring | Repair wiring |
Pinion gear teeth broken or Starter | Replace | |
Ring gear teeth broken | Replace fly wheel or torque converter |
Intake Actuator: Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and groun ...
Front Lower Arm: Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 07.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bo ...