Kia Optima Manuals

Kia Sportage: Underdrive Brake Control Solenoid Valve(UD/B_VFS): Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Underdrive Brake Control Solenoid Valve(UD/B_VFS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS): Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).

3.
Remove the air cleaner assembly.
(1)
Disconnect the breather hose (A) and brake booster intensifier hose.
(2)
Disconnect the air intake hose and then remove the air cleaner assembly (B).
Tightening torque
Hose clamp bolt:
2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)
Air cleaner assembly bolts:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

4.
Disconnect the solenoid valve connector (A).

5.
Measure resistance between sensor signal terminal and ground terminal.
6.
Check that the resistance is within the specification.
Removal
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in Hydraulic System of this group)
Underdrive Brake Control Solenoid Valve(UD/B_VFS): Schematic Diagrams
Circuit Diagram ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS): Description and Operation
Description Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Other Information:

DBC (Downhill brake control) indicator
The DBC indicator will illuminate when the DBC button is pressed and the system is on. When driving down a steep hill at a speed under 35 km/h (22 mph), the DBC will operate and the DBC indicat ...

Passive Occupant Detection System (PODS): Description and Operation
Description The system is intended to classify the occupancy status of the front passenger seat in a motor vehicle based upon the measured force on the bottom seat cushion. The system also com ...

Categories

Copyright www.kispmanual.com 2014-2026