WARNING - Windshield heating
Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection to the position and fan speed control to the lower speed.
Blower Unit: Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad and heater blower unit.
(Refer to HA group - "Heater Unit")
3.
Remove the heater blower unit (A) fro ...
ICM (Integrated Circuit Module) Relay Box: Repair procedures
Inspection
Rear Wiper Relay
Check for continuity between the terminals.
1.
There should be continuity between the No.11 in the A and
No.12 in the A terminals when power and ground are connect ...