Kia Sportage: Windshield Deicer: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Windshield Deicer / Windshield Deicer: Repair procedures
| Inspection |
| 1. |
Remove the cowl top cover.
(Refer to the wiper) |
| 2. |
Disconnect the windshield deicer connector (A) from the wiper motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay.
Body control module ...
Windshield Deicer Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to BE - "Audio")
3.
Remove the heater and A/C controller (A) after disconnecting the con ...
Other Information:
4WD LOCK indicator
The 4WD LOCK indicator light is illuminated when the 4WD LOCK button is pushed.
The purpose of this 4WD LOCK mode is to increase the drive power when driving on
wet pavement, snow-covered roads ...
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives
the vehicle identification number (VIN). ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026