Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector. |
3. |
Remove the OTS. |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector (A). |
3. |
Remove the OTS. |
Installation |
1. |
Installation is reverse of removal. |
Inhibitor Switch: Specifications
Specifications
? Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
?PP-RRR-NNN-DDS112V12V00000S2012V12V12V00 ...
Relay Box (Passenger Compartment): Repair procedures
Inspection
Fuse
1.
Be sure there is no play in the fuse holders, and that the fuses are held securely.
2.
Are the fuse capacities for each circuit correct?
3.
Are there any blown fuses?
...