Kia Sportage: ESC (Electronic Stability Control) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions and under normal driving conditions, the ESC indicator will remain off. When a slippery or low traction condition is encountered, the ESC will operate, and the ESC indicator will blink to indicate the ESC is operating.
If this indicator illuminates and stays on, the ESC may have malfunctioned. Take your vehicle to an authorized Kia dealer and have the system checked.
Malfunction Indicator Light (MIL) (check engine light)
This indicator light is part of the Engine Control System which monitors various
emission control system components. If this light illuminates while driving, it
indicates that a potential malfun ...
ESC OFF indicator
The ESC OFF indicator will illuminate when the ignition switch is turned ON,
but should go off after approximately 3 seconds. To switch to ESC OFF mode, press
the ESC OFF button. The ESC OFF ind ...
Other Information:
Output Speed Sensor: Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(R ...
Room Lamp: Repair procedures
Inspection
1.
Remove the room lamp assembly connector then check for continuity between terminals.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) fro ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual