Description |
1. |
The intake actuator is located at the blower unit. |
2. |
It regulates the intake door by signal from control unit. |
3. |
Pressing the intake selection switch will shift between recirculation and fresh air modes. |
Front Strut Assembly: Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub ...
Injector: Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within t ...