Kia Sportage: Rheostat: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Rheostat: Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad") |
| 3. |
Remove the crash pad side switch assembly (A) after loosening 2 screws.
|
| 4. |
Remove the side crash pad switch after disconnecting the connectors (A).
|
| 5. |
Operate the switch and check for continuity between terminals with an ohmmeter.
|
Hazard Lamp Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to BE group - "Audio unit")
Take care not to damage and sc ...
Front Fog Lamps: Repair procedures
Inspection
Front Fog Lamp Switch
1.
With the fog lamp switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the mul ...
Other Information:
Water pump: Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed.
2.
Remove the drive belt (A) after turning the drive belt ten ...
Checking the coolant level
WARNING - Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating or
hot. Doing so might lead to cooling system and engine damage.
Also, hot coolant or s ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026