Kia Sportage: 4WD LOCK indicator
The 4WD LOCK indicator light is illuminated when the 4WD LOCK button is pushed. The purpose of this 4WD LOCK mode is to increase the drive power when driving on wet pavement, snow-covered roads and/or off-road. The 4WD LOCK indicator light is turned off by pushing the button again.
CAUTION - 4WD lock mode
Do not use 4WD LOCK mode on dry paved roads or highway, it can cause noise, vibration or damage of 4WD related parts.
4WD system warning light
When the ignition switch is turned to the ON position, the 4WD indicator will
illuminate and then go off in a few seconds.
If the 4WD system warning light illuminates, this indicates that there i ...
LCD display warning
Key not in vehicle
If the smart key is not in the vehicle and if any door is opened or closed with
the ENGINE START/STOP button in the ACC, ON, or START position, the warning illuminates
on the L ...
Other Information:
Thermostat: Repair procedures
Removal and Installation
Disassembly of the thermostat would have an adverse effect,
causing a lowering of cooling efficiency. Do not remove the thermostat,
even if ...
Yaw-rate and Lateral G Sensor: Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console upper cover.
3.
Disconnect the yaw rate & lateral & Longitudinal G se ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
