Kia Sportage: CVVT Oil Temperature Sensor (OTS): Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Temperature Sensor (OTS): Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the OTS connector. |
| 3. |
Remove the OTS. |
| 4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. |
| 5. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the OTS connector (A). |
| 3. |
Remove the OTS.
|
| Installation |
| 1. |
Installation is reverse of removal. |
CVVT Oil Temperature Sensor (OTS): Schematic Diagrams
Circuit Diagram
...
Accelerator Position Sensor (APS): Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors ...
Other Information:
Tail Gate: Repair procedures
Replacement
Tail Gate Trim Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the relate ...
Compressor: Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negativ ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026