Kia Optima Manuals

Kia Sportage: Purge Control Solenoid Valve (PCSV): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Purge Control Solenoid Valve (PCSV): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV): Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.
Remove the valve from the bracket in the direction of the arrow.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Use care to keep foreign material out of the valve.
   
•
Install the purge control solenoid valve after lifting the support pin (A) of the bracket.

1.
Installation is reverse of removal.
Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Purge Control Solenoid Valve (PCSV): Schematic Diagrams
Circuit Diagram ...

CVVT Oil Control Valve (OCV): Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

Other Information:

Rear Shock Absorber: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Armed stage
Park the car and stop the engine. Arm the system as described below. 1.Remove the ignition key from the ignition switch and exit the vehicle. 2.Make sure that all doors (and tailgate) and engine hoo ...

Categories

Copyright www.kispmanual.com 2014-2026