Interior A |
Front pillar trim mounting hole (O8.5) | Front pillar trim mounting hole (O7) | Cowl crossbar mounting hole (O9) |
Front door checker mounting hole (O13) | Cowl side trim mounting hole (O8.5) | Seatbelt height adjust upper mounting hole (O14.5) |
Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
Interior B |
Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
Rear door checker mounting hole (O13) | Rear seatbelt anchor mounting hole (O19) | Rear seat striker mounting hole (O9) |
Wheel house panel tooling hole (O12) | Rear door striker mounting hole (O13) | Rear pillar trim mounting hole (O8.5) |
Rear pillar trim mounting hole (O8.5) | Transverse rear trim mounting hole (O8.5) |
Interior C |
Front pillar trim mounting hole (O8.5) | Front pillar trim mounting hole (O7) | Cowl crossbar mounting hole (O9) |
Cowl side trim mounting hole (O8.5) | Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) |
Front seatbelt retractor mounting hole (O12.2) | Front seat mounting hole (O11) |
Interior D |
Seatbelt height adjust upper mounting hole (O14.5) | Seatbelt height adjust lower mounting hole (O14.5) | Front seatbelt retractor mounting hole (O12.2) |
Rear seatbelt anchor mounting hole (O19) | Rear seat striker mounting hole (O9) | Wheel house panel tooling hole (O12) |
Rear pillar trim mounting hole (O8.5) | Rear pillar trim mounting hole (O8.5) | Transverse rear trim mounting hole (O8.5) |
Rear floor panel tooling hole (O6) |
Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to either a higher or a lower gea ...
Intake Air Temperature Sensor (IATS): Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...