Kia Sportage: Room Lamp: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Room Lamp: Repair procedures

Inspection

1.	Remove the room lamp assembly connector then check for continuity between terminals.

Removal

1.	Disconnect the negative (-) battery terminal.

Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

Take care not to damage the part (B).

3.	Loosen the fixing screws (2EA).

4.	Remove the room lamp assembly (A) after disconnecting the connector (B).

Installation

1.	Install the room lamp assembly after connecting the lamp connector.

2.	Install the lamp lens after assembling the bulb.

Turn Signal Lamp: Repair procedures

Removal Rear Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to BD group - "Rear Bumper") 3. Disconnect the connector. Remove the rear ...

Overhead Console Lamp: Repair procedures

Inspection Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. No.DescriptionNo.Descrip ...

Other Information:

Don't let ice and snow accumulate underneath
Under some conditions, snow and ice can build up under the fenders and interfere with the steering. When driving in severe winter conditions where this may happen, you should periodically check un ...

Vehicle certification label
The vehicle certification label attached on the driverâ€™s side center pillar gives the vehicle identification number (VIN). ...

Kia Sportage: Room Lamp: Repair procedures

Turn Signal Lamp: Repair procedures

Overhead Console Lamp: Repair procedures

Other Information:

Categories