Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using the screwdriver, remove the cluster facia panel (A). |
3. |
Using the screwdriver, remove the crash pad garnish (A). |
4. |
Using the screwdriver, remove the screws and center facia panel (A). |
5. |
Disconnect the center facia connectors (A). |
6. |
Loosen the control panel mounting screws and then remove the control panel (A). |
7. |
Disconnect the connectors and then remove the control panel(B). |
8. |
Installation is the reverse order of removal. |
3 Point rear center belt
To fasten the rear center belt
1.Extract the tongue plate from the hole on the belt assembly cover and slowly
pull the tongue plates out from the retractor.
2.Insert the tongue plate (A) into ...
4WD LOCK indicator
The 4WD LOCK indicator light is illuminated when the 4WD LOCK button is pushed.
The purpose of this 4WD LOCK mode is to increase the drive power when driving on
wet pavement, snow-covered roads ...