Kia Optima Manuals

Kia Sportage: Pressure Sensor: Repair procedures - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sportage SL Service & Repair ManualKia Sportage: Pressure Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Pressure Sensor: Repair procedures

Inspection
   
If you have trouble code related to the pressure sensor (P1825, P1826, P1827, P1828), check pressure sensor according to the inspection process.
Pressure Sensor Inspection Procedure

Measure the resistance of pressure sensor
1.
Turn ignition switch OFF.
2.
Disconnect the pressure sensor connector.
3.
Measure resistance between sensor terminal and terminal.
4.
Check the measured resistance. (Refer to table)
Terminal
Resistance
PIN 2 – PIN 3
2.755 ~ 4.133 k?
PIN 1 – PIN 3
1.892 ~ 2.838 k?
PIN 1 – PIN 2
1.714 ~ 2.838 k?

Removal
1.
Remove the coupling assembly.
(Refer to "coupling assembly" in 4WD group)
2.
Remove the extension Cable (A).

3.
Remove the pressure sensor (A) with 24mm socket.
   
•
Keep going horizontal state to prevent leaks during remove the pressure sensor.
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)

Installation
   
•
Check the cleanliness of the pressure sensor before installation.
•
Check the pressure sensor O-ring (A).

1.
Installation is the reverse of removal.
Pressure Sensor: Schematic Diagrams
Circuit Diagram ...

Driveshaft and axle
...

Other Information:

4WD ECU: Schematic Diagrams
Circuit Diagram 4WD ECU Connector PinFunction1Oil pressure motor A2Oil pressure motor B3Lock mode switch4-5Input sensor signal(+)6-7CAN communication line (High)8CAN communication line (Low)9- ...

Anti-lock brake system (ABS) warning light
This warning light illuminates if the ignition switch is turned ON and goes off in approximately 3 seconds if the system is operating normally. If the ABS warning light remains on, comes on while ...

Categories

Copyright www.kispmanual.com 2014-2026