Kia Sportage: Front Driveshaft: Components and Components Location - Driveshaft Assembly - Driveshaft and axle - Kia Sportage SL Service & Repair ManualKia Sportage: Front Driveshaft: Components and Components Location

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Driveshaft Assembly / Front Driveshaft: Components and Components Location

Components

1. Front driveshaft (LH)
2. inner shaft
3. Front driveshaft (RH)

1. Split pin
2. Castle nut
3. washer
4. BJ assembly
5. Clip A
6. BJ boot band
7. BJ boot
8. Dynamic damper band
9. Dynamic damper
10. Shaft
11. VTJ boot band
12. VTJ boot
13. Spider assembly
14. Circlip
15. VTJ housing

1. Split pin
2. Castle nut
3. Washer
4. BJ assembly
5. Clip A
6. BJ boot band
7. BJ boot band
8. Dynamic damper band
9. Dynamic damper
10. Shaft
11. VTJ boot band
12. VTJ boot
13. Spider assembly
14. Circlip
15. VTJ housing

Driveshaft Assembly
...

Front Driveshaft: Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.3 ~ ...

Other Information:

Closing the fuel filler lid
1.To install the cap turn it clockwise until it clicks once. 2.Close the fuel filler lid and push it in lightly making sure that it is securely closed. ✽ NOTICE There may be an intermitten ...

Camshaft Position Sensor (CMPS): Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON’T remove the c ...

Categories

Copyright www.kispmanual.com 2014-2026