Kia Optima Manuals

Kia Sportage: Rear Assist Arm: Repair procedures - Rear Suspension System - Suspension System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Assist Arm: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Suspension System / Rear Suspension System / Rear Assist Arm: Repair procedures

Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel & tire (A).
2.
Remove the sprit pin and castle nut or bolt and then disconnect the rear assist arm (A) from the rear axle.
Tightening torque :
2WD
44.1 ~ 53.9N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
4WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
[2WD]

[4WD]

3.
Loosen the bolt & nut and then remove the rear assist arm (A) from the sub frame.
Tightening torque :
107.9 ~ 117.7N.m (11.0 ~ 12.0kgf.m, 79.6 ~ 86.8lb-ft)
[2WD]

[4WD]

4.
Installation is the reverse of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear assist arm for deformation.
3.
Check ball joint for damage.
4.
Check for the all bolts and nuts.
Rear Stabilizer Bar: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Trailing Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Other Information:

ETC (Electronic Throttle Control) System: Schematic Diagrams
Circuit Diagram ...

Repair procedures
Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). ...

Categories

Copyright www.kispmanual.com 2014-2026