Circuit Diagram (1)
Circuit Diagram (2)
CLU1 message signal flow (B > C CAN gateway)
CLU2 message signal flow (B > C CAN gateway)
CLU message 1 signal flow (C > B CAN gateway)
CLU message 3 signa ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cluster fascia panel (A).
3.
Remove the cluster assembly (A) after loosening 4 screws.
4.
Disconnect the cluster ...
Other Information:
Rear Wiper Motor: Repair procedures
Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that ...
Air bag warning light
This warning light will illuminate for approximately 6 seconds each time you
turn the ignition switch to the ON position.
This light also comes on when the Supplemental Restraint System (SRS) is ...