Kia Optima Manuals

Kia Sportage: Rear Washer Motor: Repair procedures - Rear Wiper/Washer - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Washer Motor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Rear Wiper/Washer / Rear Washer Motor: Repair procedures

Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
   
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Remove the front bumper cover.
(Refer to the BD group - "Front bumper")
3.
Connect positive (+) and negative (-) battery cables to terminals 2 and 1 respectively to see that the washer motor runs and water is pumped.
4.
Check that the motor operates normally.
Replace the motor if it operates abnormally.

No
Description
No
Description
1
GND
2
Washer (+)

Rear Washer Switch: Repair procedures
Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch. Rear Wiper Switch Rear Was ...

Electro chromic Inside Rear View Mirror
...

Other Information:

Electric Waste Gate Actuator (EWGA): Components and Components Location
Components 1 . Housing2 . Cover 3. Sealing Cover4 . Motor5. Pinion6 . Shaft Gear7 . PCB Assembly8 . Middle Gear9 . Lever10 . Lever Pin11 . Rod - End12 . Rod ...

ESC Control Module: Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner. Tightening torque : 12.7 ~ 16.7N.m(1.3 ~ 1.7kgf. ...

Categories

Copyright www.kispmanual.com 2014-2026